Vermes
Advanced Member level 4
Rolling mill is a useful device for all kinds of housework that require such processing of metal. The construction was inspired by project described at: LINK.
To check how to create a smaller device, see:
.
Those two projects can be combined. Result is shown in the pictures:
Rolls were derived to the outside to facilitate milling „circles” and „springs”. Upper roll can be removed (it would be easier if you apply the thumb screws).
Elements used:
Limiters applied to the roll are cut from the pressure tube and prevent from sliding out the tube.
Link to original thread (useful attachment) – Walcarka metali (płaskowników, profili, rur)
To check how to create a smaller device, see:
Those two projects can be combined. Result is shown in the pictures:
Rolls were derived to the outside to facilitate milling „circles” and „springs”. Upper roll can be removed (it would be easier if you apply the thumb screws).
Elements used:
- rolls
- 10mm plate
- six bearing fittings
- screws
- electrodes
Limiters applied to the roll are cut from the pressure tube and prevent from sliding out the tube.
Link to original thread (useful attachment) – Walcarka metali (płaskowników, profili, rur)