Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Reference voltage for lm358

Status
Not open for further replies.

Murugesh_89

Full Member level 5
Full Member level 5
Joined
Nov 23, 2012
Messages
266
Helped
7
Reputation
12
Reaction score
6
Trophy points
1,298
Location
India
Activity points
3,267
Hi,
I am connecting a 5.1V zener diode at the inverting terminal of LM358 to use it as a comparator.

When i get a voltage above 5.1 in the non inverting terminal the output need to switch.

I am using 2 lm 358 ic's and uses all the 4 channel as comparator as said above.

My doubt is shall i connect all the inverting terminals of 4 opamp's so that i can use single zener diode or should i have separate zener diodes for reference voltage?

Thanks,
Murugesh
 

How accurate does your reference need to be?
A zener is not going to give you a very accurate reference. It may well be good enough for your
application , don't know. You can connect all the inputs to the same zener , as "theoretically" they don't draw any current.
In practice this is not the case , but the current draw is still pretty small.
Again , all depends on your accuracy required.
Neddie
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top