Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Auxiliary power supply once the push pull starts - what powers the chip to provide the gate drive at cold start is not shown / not drawn / not provided in the schematic - likely an unfinished "design" ...
Using the winding only to power the feedback opto coupler doesn't make sense.
But I presume you can read schematics good enough to see that the driver power supply is not shown in the drawing. That's more a functional block diagram than a real schematic.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.