Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PTZ controller - question concerning commands and protocol

Status
Not open for further replies.
O

oldmp

Member level 1
Joined
Feb 20, 2004
Messages
37
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
333
PTZ controller

hi,

I own a Panasonic WV-CS650 dome camera, with PTZ controlling possibility. But this type of camera uses the video signal cable to communicate with the PTZ controller (there are no cables for rs485, just the 230V AC input, and the coaxial video output cable)

I searched with google for a protocol, or any type of information related the hardware interface, protocol, etc.. but without result..

How are the controlling commands mixed to the video signal? is the protocol the same as used by the normal RS485 panasonic controllers?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top