Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PSS and PAC simulation setting

Status
Not open for further replies.

mirrobbs

Newbie level 5
Newbie level 5
Joined
Sep 23, 2010
Messages
10
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,281
Location
Denmark Aarhus
Activity points
1,339
Hi there.

I'm designing a chopper amplifier. And I want to use PSS and PAC to acquire the voltage gain of the chopper amplifier. I have obtained some prelimilary results. But I want to know more specifically about to how to set the 'harmonic' option in the PSS and 'sideband' option in PAC. Since the chopper frequency is merely 1kHz and the bandwidth of the singal is 0.5Hz to 100Hz, should I take the harmarnic and sideband into consideration? Currently I just give both 0 to these options. Is there anyone can help me?

Thanks in advance.

Best regards
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top