Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PROTEL 1.5 and 2.5 problem

Status
Not open for further replies.
Medtronic

Medtronic

Full Member level 5
Joined
May 19, 2005
Messages
246
Helped
29
Reputation
58
Reaction score
16
Trophy points
1,318
Location
Egypt
Activity points
2,695
Dear all my friendes
i have a problem with protel 1.5 and also protel ver 2.5 that when i print out my design all pads have the same drill hole width which is small even i have a pad hole size say 100 mil that printed as ic pad hole size 30 mil how can solve this prolem

best regards

MedTronic
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top