Medtronic
Full Member level 5
Dear all my friendes
i have a problem with protel 1.5 and also protel ver 2.5 that when i print out my design all pads have the same drill hole width which is small even i have a pad hole size say 100 mil that printed as ic pad hole size 30 mil how can solve this prolem
best regards
MedTronic
i have a problem with protel 1.5 and also protel ver 2.5 that when i print out my design all pads have the same drill hole width which is small even i have a pad hole size say 100 mil that printed as ic pad hole size 30 mil how can solve this prolem
best regards
MedTronic