smiles
Advanced Member level 4
GTP-USB
Hi ! I have a charge circuit for PIC named GTP-USB, like this **broken link removed**
Then I use printer cable, one end connect with the port placed in circuit, one end connect with USB port of computer.
The hardware driver setup screen appears, I follows the wizard and at last it says "The hardware was not installed because the wizard cannot find the necessary software"
I had winpic800 installed.
Could you tell me what wrong that I got ?
Thanks so much !!!
Hi ! I have a charge circuit for PIC named GTP-USB, like this **broken link removed**
Then I use printer cable, one end connect with the port placed in circuit, one end connect with USB port of computer.
The hardware driver setup screen appears, I follows the wizard and at last it says "The hardware was not installed because the wizard cannot find the necessary software"
I had winpic800 installed.
Could you tell me what wrong that I got ?
Thanks so much !!!