Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problem in FFT analysis using powerGUI in MATLAB simulink.

Status
Not open for further replies.

prem123

Newbie level 5
Newbie level 5
Joined
Jul 11, 2012
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,380
I have implemented a model related to power electronic converter in MATLAB simulink. it is a custom model which is created by using MATLAB functions and equation blocks. Although I have included power GUI inside the model, my output waveform of the scope does not show in the FFT window. it shows "Error in FFT window settings".
Are there any standards in Power GUI when using a custom model like this??
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top