Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Power probe fuse help in identifying

Status
Not open for further replies.
wizpic

wizpic

Advanced Member level 3
Joined
May 23, 2004
Messages
789
Helped
108
Reputation
216
Reaction score
72
Trophy points
1,308
Location
London
Activity points
6,358
I borrowed a friend m a sealey power probe PP1 V3 and it looks like he has blown as there is no continuity between the terminals, It has got some markings on it, See photo attached.
The markings are TS-G24A and the small number is 19F28
I've tried searching but drawn blanks, I've been told that they don't sell spare parts for them.
Has anybody got any ideas on the size of it or advise what it could be even if I can find a equivalent resettable fuse

Thanks
 

Attachments

  • power probe.jpg
    power probe.jpg
    26 KB · Views: 138

Are you sure that it's a fuse?
Can you attach a photo of the solder side?

Just found a video on YT, and saw that it has the possibility of powering using the switch.
So, logic says that the fuse should be 10+ amps :)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top