lmtg
Member level 3
I get a wierd error upon running post route simulation. The simulation does run but not as should be.
Any ideas what might have caused the error??
Does it affect the simulation or can it be ignored??
Finished circuit initialization process.
at 0 ns(1): Error: */X_DSP48 HOLD Low VIOLATION ON CEA WITH RESPECT TO CLK;
Expected := 0.09 ns; Observed := 0 ns; At : 0 ns
at 0 ns(1): Error: */X_DSP48 HOLD Low VIOLATION ON CEB WITH RESPECT TO CLK;
Any ideas what might have caused the error??
Does it affect the simulation or can it be ignored??
Finished circuit initialization process.
at 0 ns(1): Error: */X_DSP48 HOLD Low VIOLATION ON CEA WITH RESPECT TO CLK;
Expected := 0.09 ns; Observed := 0 ns; At : 0 ns
at 0 ns(1): Error: */X_DSP48 HOLD Low VIOLATION ON CEB WITH RESPECT TO CLK;
