zia.newversion
Member level 5
The project file is attached.
I am trying to build and load this LED-ON program on my newly acquired PICKit 3 Demo Board (w/ PIC18F45K20). Everything is fine, the programmer is supposed to be powering the board, the voltage is set to 3.25V, there is no error in build, there is no error in programming/verifying. YET, the LED refuses to glow.
And in Debugger -> Settings -> Status (Tab) the PICKit3 VDD is 0.00V... I can't get it. The program was downloaded from Microchip websites and is supposed to be an introductory lesson for PICKit3 Debug Express...
If someone could kindly have a look at the code and explain what I am doing wrong, I shall be duly grateful.
I am trying to build and load this LED-ON program on my newly acquired PICKit 3 Demo Board (w/ PIC18F45K20). Everything is fine, the programmer is supposed to be powering the board, the voltage is set to 3.25V, there is no error in build, there is no error in programming/verifying. YET, the LED refuses to glow.
And in Debugger -> Settings -> Status (Tab) the PICKit3 VDD is 0.00V... I can't get it. The program was downloaded from Microchip websites and is supposed to be an introductory lesson for PICKit3 Debug Express...
If someone could kindly have a look at the code and explain what I am doing wrong, I shall be duly grateful.