Nancy12345
Junior Member level 3
Hi,
I am doing parasitic inductor extraction using Calibre PEX, but inductors are unable to be mapped in calibre view since there is no cell present for parasitic inductor in TSMC 180 nm library. So simulation using config view is not giving correct results.
I have the pex netlist with extracted inductors, capacitors and resistors and I want to run it through terminal directly.
Can someone please tell me how to do that?
Thank you
I am doing parasitic inductor extraction using Calibre PEX, but inductors are unable to be mapped in calibre view since there is no cell present for parasitic inductor in TSMC 180 nm library. So simulation using config view is not giving correct results.
I have the pex netlist with extracted inductors, capacitors and resistors and I want to run it through terminal directly.
Can someone please tell me how to do that?
Thank you