Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

P-CAD DOS Schematic transfer problem with PDIFOUT

Status
Not open for further replies.
R

RussH

Newbie level 6
Joined
Jul 7, 2008
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,380
Hi all

A problem with PDIFOUT.EXE

Have been using this to convert old DOS circuits to P-CAD 2002 with no problem.
Anyway, went to use it yesterday to convert a circuit, and it started to run, then came up with:

ERROR: Could not open Message file.

Not had this before, and as said was working OK last time.
Has the wonderfull old PC changed some settings while asleep? It's an old 386 that only gets used for this purpose.

Any ideas?
For information the PCB program OUTPDIF.EXE works OK!

Regards
Russ
 

Update

Got hold of PDIFOUT5.EXE & EXP

When I tried to convert I got this message:-

os289: Cannot remove kernal. Another program has been installed on vector chain.

mmm.....lost

Regards
Russ
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top