Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Output impedance of RF filter

Status
Not open for further replies.

milansedlak

Newbie level 4
Newbie level 4
Joined
Feb 22, 2018
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
74
Hi guys,
does anyone know, how to design filtr with specific output impdeance? I've done some research on internet and there are calculators, tips etc. how to design filtr with 50 ohms of input and output impedance. But I need filter with complex output impedance (viz. attachement).
Could somebody help me?
Thank you.

eda_borad.png
 

You can design this filter for 50 Ohm Source and Load Impedances then you can add an Impedance Matching Circuit to desired side to obtain wanted Impedance value.
 
Good filter design tools like Nuhertz Filter Solutions can design passive filters for complex source and load impedance. As known from dedicated impedance matching networks, there's a relation between impedance ratio and achievable minimal Q.

I presume, the design procedure is also derived in profound filter text books.
 

I see the problem discussed e.g. in Zverev, Handbook of Filter Synthesis in paragraph 10.13 Source and Load Transformations.
 

A complex output impedance will always be frequency dependent?
 

A complex output impedance will always be frequency dependent?

Yes. You can possibly assume a constant value for small band filters. Said "Source and Load Transformations" paragraph is using RL or RC series circuits instead of absolute impedance values. Nuhertz is expecting an impedance table for the general case.

Please notice that filters are designed for a nominal termination impedance not an output impedance. The passband output impedance is the complex conjugate of the load impedance.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top