Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i want to switch on and off a dc fan using mosfet depending upon lm35 output. so i build the below circuit, but it does not work. can some one please tell what i am doing wrong?
op amp pin 2 is at 0.25v and pin 3 at 0.32v
R11 is not connected.
VCC is 12v
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.