Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Noise correlation simulation in pnoise

Status
Not open for further replies.
A

analog_chip

Full Member level 1
Joined
Oct 9, 2011
Messages
99
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,994
Hi,

1. I am using IC6.1.6-64b.500.1 and my simulator version is 10.1.1.296.isr18 64 bit

2. I am simulating a basic downconversion mixer as shown in attached figure. I want to know the correlation between noise at RF (red) and noise at IF (blue). I tried to follow the following article:
https://www.cadence.com/rl/Resources/white_papers/tdnoise.pdf

In page 7, it uses noisetype=correlations. But this option is not available in this version. How shall I find my required correlation.

I shall highly appreciate if some provides me an appnote or the steps.
5443235700_1412317426.jpg
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top