Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

neutral problem in circuit DC circuit

Status
Not open for further replies.
There will be a certain transformer inductance, which is unfortunately unspecified in the datasheet as I already mentioned.

But 12 mArms can be read as a maximum rating that shouldn't be exceeded. Respectively you can be sure that an OP with15 or 20 mA output current will be sufficient to drive the LVDT at full level. As already mentioned by others, there's no reason to use a power OP like TDA2030.
 

How can you say that , if 12 mArms is input for coil than 3.5 V rms can also be input of coil, may be. I do't understand what does it mean 3,5V RMS with load 1 MOhm//360pF
 

3.5 V drive voltage and 1 Mohm receiver coil load are the conditions to achieve the specified sensitivity.
 

drive voltage means primarily coil voltage?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top