Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need advice about using the LPC 2294 to sniff SPI packet data

Status
Not open for further replies.
S

saudrehman

Member level 1
Joined
Dec 20, 2005
Messages
40
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,697
Hi i am using the LPC 2294 to sniff SPI packet data.
Can i use the SPI Engine of LPC 2294 to do that
i want to sniff the SI,SO data both of SPI Communication taking place between two controllers
or should i use GPIO triggered by the SCLK edge triggered external Interrupt
Please give me some ideas and if possible code for the same.


Also i want to send this data via ethernet to a PC.
How should i go about that
should i use a http webserver ??

Please advice.......
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top