Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Mosfet gets short when powered

Status
Not open for further replies.

shoaib909

Newbie level 1
Newbie level 1
Joined
Sep 3, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Dear guys i m trying to make a H-bridge by using Mosfet i m using irf9530 (p-channel) and irf510 (N-channel) mosfets without power there is no shorting between source and ground as i give the power they short and my irf9530 gets hot
https://www.bristolwatch.com/ele/h_bridge.htm i am using this circuit
 

You've probably wired something wrong.

But what do you mean "between source and ground"? The source of your n-channels ARE connected to ground; the sources of your p-channels are connected to power if you did it right. And you say "I am using this circuit", and then attached FIVE circuits. We are not mind readers, you know.
 

The circuit shown in the link is merely didactic.
We can´t see any protection circuit transistor (snubber).

Also, you did not inform the motor power.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top