Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
We are using Fullwave from Rsoft. I tried to simulate LHM structures by fullwave. But it turned out to be very memory consuming and very slow. I asked about this issue to the company. They will add local meshing capabilities to fullwave in the near future. So I think when this is added it will be possible to simulate LHM structures in fullwave. At the moment what you can try is the following. Set up a unit cell composed of one or two layers of LHM material and use the periodic boundary conditions. This will reduce the memory requirement significantly. I hope this helps.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.