Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

mixer simulation

Status
Not open for further replies.
Z

zxcv2201

Member level 1
Joined
Dec 4, 2021
Messages
35
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
395
If an impulse with the same frequency enters the RF and LO input of the mixer, DC output comes out, so I don't need to check IIP3, etc.?

Also I'd like to know which simulations would make sense to run in this case, and why.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top