tyassin
Advanced Member level 1
lumped components
Hi
If I would like to make a Wilkinson microstrip power divider, is it possible for MWO to somehow include the isolation resistor. Either in the EM-simulation orafterwards by incorporating the layout with the schematic.
I have done this in ADS and then applied internal ports where the resistor is placed. Afterwards the EM-simulation, it is possible to import the simulated layout into the schematic where I can use a lumped resistor.
Please advise
Regards
Hi
If I would like to make a Wilkinson microstrip power divider, is it possible for MWO to somehow include the isolation resistor. Either in the EM-simulation orafterwards by incorporating the layout with the schematic.
I have done this in ADS and then applied internal ports where the resistor is placed. Afterwards the EM-simulation, it is possible to import the simulated layout into the schematic where I can use a lumped resistor.
Please advise
Regards