mcoster
Member level 2
Hi everybody,
I am making a school project using 8051, ADC, LCD and serial com.
I am making my prototypes using a protoboard. The problem is that i got random errors happening.
I would like to hear from the most experienced ones if these errors can be caused by the protoboard (bad) isolation to high frequencies, since my source code seems to be ok ?
I am using a 12 MHz clock as 8051 clock, my boud rate for the serial port is 2400 bps.
thank you very much.
mcoster
I am making a school project using 8051, ADC, LCD and serial com.
I am making my prototypes using a protoboard. The problem is that i got random errors happening.
I would like to hear from the most experienced ones if these errors can be caused by the protoboard (bad) isolation to high frequencies, since my source code seems to be ok ?
I am using a 12 MHz clock as 8051 clock, my boud rate for the serial port is 2400 bps.
thank you very much.
mcoster