praneshcn
Member level 5
Hi,
I am trying to minimize clock skew in my design and i found a command "run timing adjust skew" which can used in cts. But when i gave the command i got the following error. any suggestions.
mantle[182]:>run timing adjust skew $m $l -effort high -clear
MSG-10 While running 'run timing adjust skew /work/demod/demod /cl013lv -effort high -clear':
CLK-7 ERROR: This command will set latency forces. Latency forces can only be set in 'ideal' clock mode. However, the current clock mode is 'computed.'
thankz
I am trying to minimize clock skew in my design and i found a command "run timing adjust skew" which can used in cts. But when i gave the command i got the following error. any suggestions.
mantle[182]:>run timing adjust skew $m $l -effort high -clear
MSG-10 While running 'run timing adjust skew /work/demod/demod /cl013lv -effort high -clear':
CLK-7 ERROR: This command will set latency forces. Latency forces can only be set in 'ideal' clock mode. However, the current clock mode is 'computed.'
thankz