Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i do nand3, with input name is ina,inb,inc, output name is out.i begin to study about layout so i have a lot of hardly.error is pin name input,isn't it ?
schematic is pass, DRC is pass,extract is pass but LVS isn't pass if you need my file i can upload for you
you can not assign pins arbitrarily. although when you swap pins the functionality remains, if the pins are not connected in layout the same way they are in schematic then lvs will not pass. this is common mistake i've seen in static logic layout.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.