LPC2138 ADC0.0 Simulation Problem in Proteus

[Harish123]

The LCD display is "working" when I don't connect the potentiometer to ADC 0,
but NOT working when I give input to ADC 0. I have attached my file below.

 

[tepalia02]

Check the connection between the AD0.0 and the 3rd pin of the variable POT. AD0.0 pin is gray. That means the signal from the POT is not reaching this pin.

 

[KlausST]

Hi,

I expect there is a problem with your microcontroller software.

I don´t have a .rar decoder on my device. What´s inside the file?

Klaus

 

[Harish123]

Hi,

I expect there is a problem with your microcontroller software.

I don´t have a .rar decoder on my device. What´s inside the file?

Klaus

thanks, here is the hex file and proteues file

 

[KlausST]

Hi,

a lot of files. Most of them are more than 10 years old.
Only one HEX file. Surely not compiled recently.
So what are your files?

* Focus on the problem
* give clear error descriptions

I won´t go through 1MBytes of files that you collected somewhere from the internet.

Klaus