elockpicker
Member level 4
Hi,
I have an Xess board (Spartan 3) which does not support 0-5 Volt logic levels.
Can I use Low Power ATmega microcontrollers to communicate with it ?
Is it just sufficient to set the VCC (of micro) to the appropriate high logic level ?
thank you
I have an Xess board (Spartan 3) which does not support 0-5 Volt logic levels.
Can I use Low Power ATmega microcontrollers to communicate with it ?
Is it just sufficient to set the VCC (of micro) to the appropriate high logic level ?
thank you