Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

locking two signals in Simulink

Status
Not open for further replies.
B

buraka

Newbie level 2
Joined
Dec 23, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Turkey
Activity points
1,293
i want to lock two signals that one is the sawtooth signal at 5V@50Hz, the other is main 50Hz in Simulink. How can i achieve it? That is very important and urgent for me .
Many thanks
 

Hi buraka !

Here is the model in Simulink (Matlab ver. 7.1) that you search.
 

AlBo said:
Hi buraka !

Here is the model in Simulink (Matlab ver. 7.1) that you search.
Click to expand...

Hi Albo,
Thanks your interest. i am sending my simulink file. The circuit wiil work as a temperature controller. i generate a sawtooh waveform using Signal generator. You can seeat top of mdl file. But this signal have to synchronize with main voltage 220V@50Hz. i can use a voltage transformer(220V/6V) to take sample from main because my dac card works max 10V. But how can i synchronize these signal? What is your opinion?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top