Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Connecting load cells must be done with the right material :
a load cell is basically an high precision resistor.
So a Δ wheight gives a Δ resistor. You can measure this with a millivoltmeter.
Of course the wiring of your loadcell to your plc as a direct influence on your
measure.
If you really want o use a S7-200 try to find a module that convert the measure of the
wheight to a 4-20 mA signal which is easier to handle with a PLC.
Try Metler Toledo they are specialists on the wheighing field you ll maybe find such
module
In fact S7-200 is low range PLC of Siemens. You could find certainly more accuracy
on S7-300/400. So is Profibus a standard on the industry, you may find an interface
that can handle the connection with the load cell and give the result as a profibus slave.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.