Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

LM2575-ADJ negative voltage output

Status
Not open for further replies.
S

stoyanoff

Full Member level 4
Joined
Aug 10, 2011
Messages
195
Helped
8
Reputation
16
Reaction score
8
Trophy points
1,298
Activity points
2,725
Greatings! I saught this schematic in the LM2575-ADJ datasheet - LM2575.jpg
This is for LM2575-12. Is it possible to use this schematic for LM2575-ADJ with adding voltage devider on the feedback pin? Is the algorith for calculation of the devided the same?!
Thanks!
 

Assuming you bought the adjustable version, yes there is. Page 12 shows the calculation for doing the voltage divider to set your output. **broken link removed**
 

Greatings! I saught this schematic in the LM2575-ADJ datasheet - lm2575.jpg
This is for LM2575-12. Is it possible to use this schematic for LM2575-ADJ with adding voltage devider on the feedback pin? Is the algorith for calculation of the devided the same?!
Thanks!
Click to expand...
Hi stoyanoff
Of course it can be yielded by any type of LM2576 . but with some little changes . for more information refer to the datasheet and read it carefully .

Best Wishes
Goldsmith
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top