Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[General] Is USB protocol half duplex or full duplex communication?

Status
Not open for further replies.

poojarai

Newbie level 6
Joined
Dec 26, 2010
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,342
I am little confused whether USB protocol is half duplex or full duplex. After Googling ,get to know
1.x or 2.0 communication is half dulpex and 3.0 is full duplex but not very sure. Please anyone clear my doubt.
 

Hi,
USB has deferential protocol for communication.
Basically, for full duplex communication in differential fashion, minimum 1 pair for Tx data line and minimum 1 pair for Rx data lines are must.
While USB has only 1 pair of data lines (D+, D-), so USB would be half duplex protocol.

Thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top