Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Look this schematic....I think that you have problems because you dont have delay circuit. When you turn on high side and switching off low side without dalay you have short circuit between supply and ground for very small time, but that is enogh for heating. In this schematic D1,C1 and R1 make hardware dalay. You can also make software delay.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
