Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

interfacing of zigbee

Status
Not open for further replies.

devidasbkarale

Newbie level 3
Newbie level 3
Joined
Dec 19, 2010
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,299
can anybody tell me how i can connect zigbee pro interface board with atmega 16 microcontroller?
 

Hello devidasbkarale!
Interfacing XBEE Pro with Atmel controller is very easy.

All you have to do is
1- connect Rx pin of ATMega16 with Pin 2 of XBEE directly because XBEE's signal would be 3.3V and ATMega16 accepts signal at the level of 3.3V.
2- connect Tx pin of ATMega16 with Pin 3 of XBEE provided that there should be two resistor in line. one resistor of 1.8Kohms in series and one 3.3Kohms in parallel after first resistor. Now if u see, after 1st resistor, the 2nd resistor (3.3K) would be parallel to pin 3 and ground of XBEE. (to drop 5V signal to 3.3V)
3- Use switch mode power supply regulator idealy LM2576-3.3 is easily available in the market which is best source to provide 3.3V with 470uF inductor, 1N5822 fast switching diode 470uF cap at input and 680uF cap at output of LM2576-3.3. Remember must use 100uF cap across Vcc and Ground of XBEE. see datasheet of LM2576.

For any other detail, please feel free to ask.
Regards
Assad Mahmood
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top