Increasing component drill size on Orcad

[ex4]

orcad drill holes size

hello,
can anybody tell me how to make a drill hole of a component larger on Orcad??
the default is so small :|:|

 

[vsgiri]

orcad duplicate drill sizes

hi ex4,
you will have to the padstacks spreadsheet and adjust the values there!

Giri

 

[ex4]

manual orcad layout bigger holes

yes, done that on the drill layer of each pad, no help at all when i print it
can you show me some example step , i very confused here

 

[gameelgamal]

drill size

I have the same problem, I have changed the drill hole size in drill layer
but the design is printed with the default drill hole size

 

[alex_epds]

orcad via drill size

why, it's so simple in the Orcad to change the drill size

 

[gameelgamal]

orcad 10 changing component hole size

why, it's so simple in the Orcad to change the drill size

Could youn please explain how to do that??

 

[borisov57]

orcad changing a component hole size

Drill of 14 mils is hard coded in software ( for drill assistance for hand drilling).
I find it good size for drilling guide purpose. If you need bigger holes, than you must produce gerbers without drill holes open, than open gerbers in gerbtool, import nc-drill and make composite layers with them ( copper layer is dark, drill layer clear).
Now you have full control over drill sizes.

Hope this helps