Alfie_Guo
Newbie
Hi, I am doing a simulation about the WPT coil and have a problem with impedance matching circuit simulation in HFSS. I set the frequency to be 13.56MHz and generated an impedance matching circuit in ADS based on the impedance of the coil, and the result seemed valid in ADS. However, when I added that circuit to the initial coil model in HFSS by lumped RLC boundaries, the S11 and impedance results went wrong. In addition, the circuits were successfully analyzed without the coil model in HFSS. I have checked the settings and had no ideas about what went wrong.
I have attached the simulation files and results to the post. Any help would be much appreciated.
I have attached the simulation files and results to the post. Any help would be much appreciated.