How to transfer some data with FlashPro through JTAG into Actel Fusion FPGA ?

[Dayn]

Hello everybody,

I'm looking for the way to transfer some datas (like .hex files) with FlashPro soft through JTAG into Actel Fusion FPGA.

The FlashPro UG explain how to programming but not how to transfer datas.

Can Somebody help me to find a way to make that with FlashPro soft ?

I'm looking for that, because I want to save these Datas into a Flash memory linked to this FPGA.

best regards,

Dayn

 

[kathalebm]

Hello everybody,

I'm looking for the way to transfer some datas (like .hex files) with FlashPro soft through JTAG into Actel Fusion FPGA.

The FlashPro UG explain how to programming but not how to transfer datas.

Can Somebody help me to find a way to make that with FlashPro soft ?

I'm looking for that, because I want to save these Datas into a Flash memory linked to this FPGA.

best regards,

Dayn

Hi Dayn,
Check if the following tutorials can help you
Cortex-M1 Hardware tutorial and Cortex-M1 Software tutorial.
Benjamin

 

[Dayn]

Hello Benjamin

Thanks for helping me !

I found my solution, 2 solutions by the way :

- use NVM with JTAG
- use RS232 TX to transfer with a pin not use by JTAB link to transfert into RAM.
You know?

Best regards

Dany