matrixofdynamism
Advanced Member level 2
When using on-chip memory, we can read/write it just as we can configure the FPGA. However, provided that I am going to use the off-chip memory perhaps an SDRAM to store the Nios II program, how would I go about doing that?
Reading the instructions from the SDRAM is quite simple, we just createa an SDRAM controller in the Qsys and connect the instruction master to it. Done. However, I am not sure how to store the program code into it in the first place.
Reading the instructions from the SDRAM is quite simple, we just createa an SDRAM controller in the Qsys and connect the instruction master to it. Done. However, I am not sure how to store the program code into it in the first place.