Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to simulate a design with a psl file using Modelsim?

Status
Not open for further replies.
Re: PSL file-Modelsim

Hi,

Here is a do file under the name "do.do" ; it includes all the commands including those that force the signals.
So add this file to the folder including the design.
and then use the command :
do do.do
and check your wave window.
 

    Laverne

    Points: 2
    Helpful Answer Positive Rating
Re: PSL file-Modelsim

i got the same result as yours with your do file. :D
very nice.

will take a look at the do file and hopefully i can use it as a basic for the rest of my future designs.

thanks to all for your help, especially walid farid. very much appreciated!

regards
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top