how to show pin out in a layer-gerber-using 16.5?

[danismith]

hi,
i have completed my board with single layer successfully.but when i gave the board for fabrication i got a reply that,i need to show pin out for fabrication.
i have generated the gerber by setting the design parameter->disply->enhance display mode (all in ON condition).

but he is keep on telling the same message to show the pins, on the layer.

so help me how to do this?

 

[FvM]

I don't think that "pin out" is a clear term related to PCB. Which information is missing in the gerber data? I presume you are talking about PCB fabrication, not assembly?
Necessary files for a single layer board are
- signal (copper)
- soldermask
- board outline
- NC drill

 

[sivamani]

Have you enabled pins on outer layers or not?