Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to pour cooper in my case?

Status
Not open for further replies.

sonicss

Member level 1
Member level 1
Joined
Sep 6, 2004
Messages
40
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
China
Activity points
314
In Mentor WG2004 (Expedition PCB)

I finished route the trace expect gnd. I want to use "pour cooper" to finish it.
 

1.) go to Setup; Setup parameters; Planes- and define what layer(s) you want to pour copper onto along with what nets you want to have on the plane (set the type Neg for an internal plane, Pos for top or bottom routing layer).

2.) go to Route; Planes; Planes processor- this is where you will define your plane outline ,clearances and auto generated connections to the planes (You can select "route boarder" to fill in the internal area, or you will have to draw a plane shape with the edit; place;plane shape menu)

Read the Help files for a better understanding of these procedures and experiment with the Planes Processor button until you get what you want.

Good Luck
 

    sonicss

    Points: 2
    Helpful Answer Positive Rating
before doing anything

1. Fix all ur routed nets.
2. add auto fanout only to gnd.
 

    sonicss

    Points: 2
    Helpful Answer Positive Rating
thank u. I have finished my work.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top