Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to model a N-well in a substrate model?

Status
Not open for further replies.
K

kienhuy

Member level 1
Joined
May 23, 2005
Messages
36
Helped
8
Reputation
16
Reaction score
4
Trophy points
1,288
Activity points
1,607
Modeling N-well

Hi all,

I was wondering how to best model a N-well in a substrate model. Is a diode model sufficient? If so, should the size simply reflect the total surface area? Any papers or documents about this would be appreciated. Thanks.
 

Re: Modeling N-well

In many cases simple N-well to psub diode model is suuficient. However in some cases there is importance also for resistance from the current point in the nwell to the nwell tie, for example when you are investigating latch-up problem.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top