Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Ok , first you should master the SPI communication i.e you should first implement at least two functions to read , write registers of the MCP 2515.
I suggest the following pseudo code
Write_CAN( register_address, register_data){
1-put oxo2 in SPI buffer --> write instruction
2- wait until transmission flag is set
3- clear flag
4- put register address in SPI buffer
5- wait until transmission flag is set
6- clear flag
7-put register data in the SPI buffer
8- wait until transmission flag is set
9- clear flag
}
Read_CAN( register_address, register_data){
1-put oxo3 in SPI buffer --> read instruction
2- wait until transmission flag is set
3- clear flag
4- put register address in SPI buffer
5- wait until transmission flag is set
6- clear flag
7-put dummy data in the SPI buffer
8- wait until transmission flag is set
9- clear flag
10- now the register data is in the SPI buffer
11-return data
}
writing these two functions will facilitate writing the remaining interface code. All what you will need then is to fill the configuration registers using the previous write_CAN function.
Is the at89s51 really necessary? There are ucs with built-in can modules (like at90canxx from atmel or there are lot of pics from microchip like the 18f4480), so you have one problem less.
i have put forward some queries about CAN controller some days before, yasser_shoukry have replied me with an algorithm,thanks.but i feel some dificult in writting C code,My project is to form aCAN network with 3 nodes,can any one help me how to transmit and to recieve the messages,then masking and filtering,iam using a PIC controller, CAN controller(MCP 2515) and a CAN transceiver(MCP2551).
hi sir..
i want to work on can protocol..using mcp2515 with atmega 8 uc..i want to ask what initial steps i should take regarding hardware and programming so that i willl able to get data from CAN protocol vehicle easily..
---------- Post added at 23:34 ---------- Previous post was at 23:32 ----------
hi seenuvel
if you done this project then kindly help me in this project..i need you help
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.