Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am also new in this field, so just provide some suggestions.
EBG generally can be implemented in following ways:
1) drilling a periodic pattern of holes in the substrate
2) etching a periodic pattern of circles in the ground plane
3) adding a periodic pattern of metallic pads which are shorted to the ground by vias
4) Uniplanar EBG
There is some rough relation between the geometrical paramters of the periodic pattern and the stopband frequency. Up to now, I decide the stopband by simulation.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
