Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Go to XSection option.just click on that.By default only Top and Bottom is there.Right click on first coloumn, you get option add layer above,blow or remove.Using this you can create required number of layers and rename it.
first of all you need to set number of layer you want to use..usually to do vcc and ground plane you need to use 3 or 4 layer..
the top and bottom layer for copper trace (if 4 layer is use). layer 2 and 3 is up to you to define which one going to be set for vcc or gnd..
then you can create a dynamic shape to represent the vcc and gnd plane..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
