Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to change the default properties of components in protel

Status
Not open for further replies.

beaver

Junior Member level 1
Junior Member level 1
Joined
Aug 2, 2009
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,410
Hi everyone,

I want to change the default properties of components in Protel. For example, if I place a resister, the name of the component and the value are both displayed. Then I change the properties of this component, and only the value is displayed. My question is how can I save this as the default properties so that the next time I place a resister only the value is displayed.

Thank you in advance.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top