How do I verify Model(equation) using MATLAB for a CMOS circuit?

[ANALA]

I have a multiplier circuit simulated using LTspice..I would wish to verify new set of delay equations for the same multiplier circuit using MATLAB...How can I do this?

 

[pancho_hideboo]

Your questions are too vague.

What do you want to do ?

 

[ANALA]

I want to verify the model for the same multiplier circuit...Most of the literature works have stated that model verification is done using MATLAB...So how do i verify the model?

 

[pancho_hideboo]

Show me your model equations in MATLAB syntax.

 

[ANALA]

I have a set of equations...Basically I want to verify these equations in MATLAB for a CMOS 8*8 multiplier.

 

[pancho_hideboo]

I have a set of equations...
Basically I want to verify these equations in MATLAB for a CMOS 8*8 multiplier.

Simply describe your equations in MATLAB syntax.
That’s all.

 

[ANALA]

The circuit has around 900 MOSFETs...So just running one equation wouldn't work...Then it would be the case of a simple CMOS inverter which has one PMOS and NMOS...

 

[pancho_hideboo]

Can you understand MATLAB and Simulink correctly ?

They treat signal flow model not energy conservative model basically.
On the other hand, SPICE treat energy conservative model.

If you would like to treat energy conservative model, use Simscape of MATLAB.