Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How define Q-factor of filter in Agilent ADS

Status
Not open for further replies.

morfozar

Junior Member level 2
Junior Member level 2
Joined
Mar 14, 2011
Messages
22
Helped
4
Reputation
8
Reaction score
5
Trophy points
1,283
Activity points
1,461
I have a selective characteristic of filter. How I can define formula of Q-factor in Agilent ADS?
I can define resonance in dB
max(dB(AC.out))
but for calculate Q-factor i need use frequency of resonance in Hz, how do it?
 

The definition of the Q factor does not depend on the used software.
Do you speak about lowpass or bandpass response?
 

I said about bandpass filter. I solve this problem, formula for define Q-factor for bandpass filter is
Q=center_freq(db(S(2,1)),0.000000001)/bandwidth_func(db(S(2,1)),3,0)
where
center_freq(Data, ReferenceBW)
bandwidth_func(Data, DesiredValue, Type: 0 - Band-pass 1 - Band-stop 2 - Low-pass 3 - High-pass)
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top