Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Home made tube amplifier SE EL34

Status
Not open for further replies.

Vermes

Advanced Member level 4
Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


Presented here amplifier is a typial Single Ended based on EL34 in the power stage operating in triode and pentode mode (selected by a switch) and ECC82 in the preamplifier operating as White follower, EM84 as a meter and EAA91 as a signal rectifier for tubes EM84. The amplifier is equipped with a semiconductor rectifier bridge for anode voltage. There is a CLC filter for the power amplifier and CLCRC filter for the preamplifier. Total capacitance of capacitors for anode voltage is equal 362uF. That capacitance is sufficient because the only hum is a result of magnetic coupling between the speaker and mains transformers. Choke has 8,1H and 140mA of permissible current, 20mA reserve. Anode voltage on the first electrolyte is 270V and approximately 245V on anode of EL34. Ug1= -14,5V.

Initially the amplifier was powered from stabilizer power supply from Elpo, and later it was changed to mains transformer.

Pictures of the amplifier:




Pictures of construction:



Those schematics needed to be modified (e.g. adding triode/pentode switch):



Link to original thread - Prezentacja mojego wzmacniacza lampowego SE EL34
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top