Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
this is not an efficient approach .it will cost much and will produce so heat so you will need large heatsinks and finally you will have a large expensive circuit.
you must use switching power supplies.
i recommend fly back topology for your application.
but you must read some about switching power supplies if you don't have enough knowledge about them.
you can find good information and some ready to build supplies here:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.